Metal Roof Cost Florida.
Metal roof cost Florida is shown here as installed price ranges for 2026, by roof size and material. Type your Florida address to get the range for your roof. Free, no signup.
Metal runs about $700 to $1,400 per square installed on industry-reference pricing, a figure not yet verified for Florida. The shingle numbers beside it come from Florida cost data, and the estimator sizes your own roof.
Metal roof cost by size.
Roofers price a metal roof by the square, and a square covers 100 sq ft of roof.
On industry-reference pricing, a 2,000 sq ft metal roof lands at about $14,000 to $28,000 installed. Bigger and smaller roofs move with the square count.
Here is that same 2,000 sq ft roof in other materials.
- Asphalt shingle. $7,020 to $11,880, from Florida cost data.
- Architectural shingle. $8,220 to $13,820, also Florida-sourced.
- Tile. $14,000 to $30,000, industry-reference pricing like metal.
Roof cost by size and material.
Pages marked as an estimate use industry-reference pricing while Florida numbers are sourced.
What metal changes after install.
A higher price up front, a longer clock after.
The extra cost buys time on two clocks: the roof's service life and the age at which carriers start asking questions.
Service life
Asphalt shingle typically lasts about 15 to 20 years in Florida weather. Metal runs longer.
Insurance clock
Shingle roofs draw carrier attention in their mid-teens. Metal sits on the same curve and reaches that point later, typically in its thirties.
Wind mitigation form
The state wind form, OIR-B1-1802, scores roof covering among its seven features, and insurers apply credits from it.
Getting a metal price for your roof.
Industry-reference pricing gives you the band. A quote for your house settles where in that band you land.
Type your address and the estimator works out the roof's size from overhead imagery, then shows a budget range for installing it, at no charge and with no account or email.
For a firm metal number, send a quote request from the estimator to partner Florida roofers. Ask each one to price the same scope.
Common questions.
Not yet. The metal figures on this page are industry-reference pricing, while the shingle prices come from 2026 Florida cost data. Treat any metal number here as an estimate and confirm it with a written quote from a roofer who has seen your house and measured the roof.
Installed cost on this site counts materials and labor, removal and disposal of the existing roof, plus the permit and the inspection. A metal quote that leaves out tear-off or the permit will look lower than it is. Ask each roofer to price the same full scope before you put the numbers side by side.
Both start at about $700 per square installed on industry-reference pricing. At the top, tile reaches about $1,500 a square and metal about $1,400. Neither figure is verified for Florida yet, and a local quote for your roof shape and size settles the difference.
Enter the street address and the estimator pulls up the house in aerial imagery, then takes the roof measurements from above. You get back a budget range for the installed job on that measured roof. No one visits, and no signup or email stands between you and the number.
Yes. Quote requests go through the estimator to partner Florida roofers, and you can ask for metal by name. Run the free roof report first to see your current roof age and material, which the roofer will ask about when pricing the tear-off and the new roof.
The free roof report shows your roof's age and material on record, with the age dated from a re-roof permit or labeled as an estimate when no permit exists. Statewide, 58% of roof ages on record trace back to an actual permit. A roofer pricing a metal job will want both facts.